« Oil level low after refill again | Main | Moved harness bar on DasSport weekender »

July 27, 2006

Adding new harness bar

I just dropped off my DasSport Weekender 4pt roll bar/cage with the welders. They are adding a new horizontal bar 3 inches above my existing one and moving the belt hoops on to that. The bar is the same as the existing ones 1.75" x 0.12 inch. This should finally get my shoulder belts at 0 degrees instead of the 20 plus ish that it is now.

I'll post photos tomorrow. Tubing was cheap, only needed 6 ft of it and shop rate was 60 per hour.

July 27, 2006 | Permalink


Post a comment